--- title: "Error Codes List" slug: "error-codes-list" updated: 2026-10-09T02:33:18Z published: 2026-10-09T02:33:18Z canonical: "support.kiosoft.com/error-codes-list" --- > ## Documentation Index > Fetch the complete documentation index at: https://support.kiosoft.com/llms.txt > Use this file to discover all available pages before exploring further. # Error Codes List | **Error codes** | **Descriptions** | **Solutions** | | --- | --- | --- | | **1** | The anti-theft lock detected not in position | Check if the anti-theft lock is good, if it is well connected and the cables are good, also check if it is in position. | | **2** | The door switch is detected not in position | Check if the door is utterly closed, check if the switch is well connected and if the switch is good. | | **3** | Elevator motor over current | Check if the elevator can run normally. | | **4** | Elevator is not reaching the bottom after maximum steps | Check if the minor switch at the bottom is good and if it is well connected. | | **5** | The largest tray number detected is larger than the tray number that the product is loaded. | Check if the cables on the slot driver board are well correctly connected. | | **6** | Back to starting point timeout | Check if there is friction between the weighing module and the shell, check if the elevator is stuck. | | **7** | Timeout while working normally | Check if there is friction between the weighing module and the shell, check if the elevator is stuck. | | **8** | Timeout while going down normally. | Check if there is friction between the weighing module and the shell, check if the elevator is stuck. | | **9** | The lock switch is not detected in position when the opening the door | Check if the pick-up door lock is at its position | | **10** | Drop sensor timeout | Check if the elevator is working normally. | | **30** | Going up for a certain distance and the original point switch is not open. | Check if the elevator motor connection is good, check if there is power output, if the elevator goes up, check if the original point switch is good. | | **31** | Anti-theft board running timeout | Check if the anti-theft board is good. | | **32** | Anti-theft board over current | Check if the anti-theft board is good. | | **33** | There is no current at the anti-theft board | Check if the anti-theft board motor is well connected. | | **34** | No product detected in the pick-up door | Check if the product there is transparent and check if the depth is smaller than 30 mm. | | **35** | There is a product in the pick-up door before the machine gives the product. | Check if there is a product in the pick-up door, and check if the pick-up door drop sensor is good. | | **36** | Product gets stuck at the slot opening | Check if there is a product stuck, check if the drop sensor is blocked after the elevator arriving at the tray, adjust the tray height or the drop sensor. | | **37** | Elevator motor open circuit | Check if the elevator motor is well connected, or replace the elevator motor. | | **40** | Slot driver board error | Check the slot driver board errors. | | **41** | FLASH erasing error | Check if there are foreign matters on the electrical parts, replace the flash. | | **42** | FLASH writing error | Check if there are foreign matters on the electrical parts, replace the flash. | | **43** | Incorrect demand | Check if there is an antenna close to the communication cable or the electric board. | | **44** | Verification error | Check if there is an antenna close to the communication cable or the electric board. | | **45** | Door not closed | Check if the door is closed, check if the door switch is well connected and the cables are good. | | **64** | Invalid motor | Check if the slot motor is well connected. | | **80** | Rotating timeout | If there is a product, check if the product sizes are good, if yes, adjust the drop sensor attenuation. | | **255** | Driver board not responding to demands | Check if the connection between the slot driver board and the elevator driver board is good. |