Please follow the steps to install the new pedestal with original kiosk of Gen 1 VC Touch 21.
1. Install the Cardan Ball
6x Carden Ball | 1x Extender | 1x L-Shaped Bracket | 12x Screw M4*16 |
|---|---|---|---|
|
|
|
|
1. Install two Carden Balls on the Extender. | |
|---|---|
|
|
2. Tighten the Carden Ball with 2 M4*16 screws, 4 screws in total. | |
| |
3. Install 4 Carden Balls on the L-Shaped Bracket. | |
|
|
4. Tighten the Carden Ball with 2 M4*16 screws, 8 screws in total. | |
| |
2. Assemble the Pedestal
3x Folding Bracket | 1x Kiosk Pedestal | 4x Hex Screw M8*20 | 18x Screw M5×20 |
|---|---|---|---|
|
|
|
|
1. Secure the Pedestal with 4 M10x60 expansion screws to floor to prevent it from tipping over. | ||
|---|---|---|
| ||
2. Install three Folding Brackets on the Pedestal with 9 M5*20 screws. | ||
|
|
|
| ||
|
| |
| ||
|
| |
3. Install the Kiosk
1x Kiosk | 6x Hex Screw M8×20 | ||
|---|---|---|---|
|
|
1. Pre-screw two M8*20 hex screws in the top holes of the L-Shaped Bracket (Be careful not to screw all in). | ||
|---|---|---|
| ||
2. Lift the Kiosk up and hang it on the pre-mounted screws through the teardrop-shaped holes. And then open the Kiosk door, screw the 4 M8*20 hex screws from the inside. Note: Two people are required to carry the Kiosk during installation. | ||
|
|
|
