【1】Electrolux Crossover Washer WE1100P
1. Before setting the Card mode, do not connect our Reader to the machine.
2. Enter the Service mode of the machine
2.1 The two wires can be short-circuited as shown in the figure to bring it into the Service mode.
2.2 You can also enter the Service mode by pressing the Service switch at the back of the panel continuously for three times within a short period of time. You can also enter the Service mode by pressing the Service switch at the back of the panel continuously for three times within a short period of time.
3. The machine displays 8888, indicating that it has entered the Service mode.
4.1 Make sure the machine has entered the Service mode. Connect two wires together, or continuously press the Service switch three times.
4.2 Press the Start button once, and the machine displays "SE".
4.3 Press and hold the button for 6 seconds until the machine displays 38.
4.4 Press the Start button once. The machine will display the current parameters as 038. 0 indicates Coin mode, and 1 indicates Card mode.
4.5 Use buttons 5 or 6 to modify the parameters of 38. In the Card mode, it is necessary to change it to 1.
4.6 Then press the "Start" button once, which will save the changes made to 38.
4.7 Exit the Service mode. Reconnect the two wires, or press the Service switch continuously for three times.
4.8 Before connecting our reader, the machine will keep displaying “----”
4.8 Check if the Card mode has been switched successfully. Press the Start button once. If the machine displays "Card", it means the switch was successful.
【2】Wascomat Crossover washer WHWF09810NM
1. Enter the Service mode. Press the Service button as shown in the picture. The machine panel will go black and all the lights will be flashing.
1) At the same time, press both "Heavy" and "Extra" buttons, and the display on the panel will show "0 00" or "1 00 000". "0 00" indicates Coin, while "1 00" indicates Card.
2) Press the "Start" button once, and the panel will display a flashing pattern.
3) Press the "Cold" button, change the number on the far left of the panel. We need to change it to 100 in order to support Serial communication.
4) Press the Start button again to save the parameter changes.
5) Exit the Service mode and press the Service button again to proceed.
6) If the reader is not connected, the panel will display ‘----’
7) Press the Start button once. The panel will display "CArd", indicating that the Card mode has been set successfully.