Please refer to the following steps below to install VC Touch 17 - through the wall.
The front view | The back view for standard wall | the back view for thinner wall |
|---|---|---|
|
|
|
For Standard Wall——204mm
1. Put the front bracket on the front of VC Touch 17 . | ||
|---|---|---|
|
| |
2. Use M10*50 Outer hexagonal bolts to fix the front bracket on VC Touch 17. Two M10*50 outer hexagonal bolts for each side, four in total. | ||
|
|
|
3. Put VC Touch 17 through the wall and make sure the front bracket is in line with the wall. | ||
|
| |
4. Put the back bracket on the back of VC Touch 17. | ||
|
|
|
5. Use M10*50 Outer hexagonal bolts to fix the back bracket on VC Touch 17. Two M10*50 outer hexagonal bolts for each side, four in total. | ||
|
| |
For Thinner Wall——120mm-146mm
1. Put the front bracket on the front of VC Touch 17 . | ||
|---|---|---|
|
| |
2. Use M10*50 Outer hexagonal bolts to fix the front bracket on VC Touch 17. Two M10*50 outer hexagonal bolts for each side, four in total. | ||
|
|
|
3. Put VC Touch 17 through the wall and make sure the front bracket is in line with the wall. | ||
|
| |
4. Open the back door of VC Touch 17, then remove four boards from the inside of VC Touch 17. | ||
|
|
|
5. Put the back bracket on the back of VC Touch 17. | 6. Use M10*50 Outer hexagonal bolts to fix the back bracket on VC Touch 17. Two M10*50 outer hexagonal bolts for each side, four in total. | |
|
|
|
7. Use M10 flange nuts to fix the M10*50 Outer hexagonal bolts from inside of VC Touch 17. Make sure the front bracket and back bracket are tightened enough with the wall. Two M10 flange nuts for each side, four in total. | 8. Close the back door of VC Touch 17. | |
|
|
|
