VC Cash HS Installation

Please follow the steps below to install VC Cash HS.

Prerequisites

Installation Area

In order to install the VC Cash HS in a safe manner, the following conditions shall be satisfied:

1) The kiosk must be placed and leveled on a horizontal, water-resistant, and sturdy pedestal capable of bearing its weight.

2) Please ensure enough space for the front door to be fully swung open for maintenance purpose. You can refer to the top-down diagram of the door swing below for clearance around the kiosk while servicing the kiosk without obstruction.

Single-Sided Kiosk

Service Area

图片 77, 图片

图片 85, 图片

3) Make sure the power supply, operating temperature and humidity complies with the Technical Data.

4) The maximum ADA height (the height from the most upper edge of Ultra VXT to the ground) is 1218 mm (47.95 inches) as shown in below diagram along with the height of the pedestal and the height from the top of the AVU Cash HS to the ground.

$E:\task\0-completed\12.13 VXT Kiosk User Manual\Bruce供图\WeChat Image_20211217131824.png, 图片$

Mounting

Router Installation (if needed)

1) Remove the Antenna Blocking plate on the kiosk, screw off the original nuts of the antenna, pass the antenna through the pre-embedded holes and fasten it with the original nuts.

2) Connect the Wi-Fi and 4G ports separately to the corresponding positions of the router.

图片 3, 图片

3) Fix the router fixing plate to the middle position of both sides with M2.5*6 screws.

4) Pass the router fixing plate through the right pre-embedded bolt and fasten it with M5 thumb nuts.

Note: Turn the router socket side outward.

图片 5, 图片

图片 1, 图片

Ultra VXT Installation

1) Fix the back plate of Ultra VXT through the pre-embedded bolts and fasten it with M5 flange nuts.

2) Pass the Ultra VXT to Serial Expander Cable (WH110051) through the remaining hole of Ultra VXT, insert one end of the cable to the COM port of Ultra VXT and fasten the two bolts of Ultra VXT with M5 flange nuts.

3) Connect the Ultra VXT Cable, Power (WH210016) with the original cable of Ultra VXT.

图片 1, 图片

图片 4, 图片

Pedestal Mounting

The installation procedure to mount the VC Cash HS on the pedestal provided by KioSoft is as follows:

1) Place the kiosk on to the pedestal. Make sure the four driving holes at the bottom are in line with those of the pedestal.

2) Drive the M10x30 screws into the holes to fix the kiosk to the bottom.

3) The kiosk is mounted to the pedestal as shown.

图片 5, 图片

图片 15, 图片

$E:\task\12.21 AVU Kiosk Series - User Manual\WeChat Image_20211221111758.png, 图片$

Warning: The kiosk along with its pedestal is quite heavy, so please ensure that the installation surface is flat. It is also highly suggested that the kiosk is installed with its back close to the wall for security purposes.