Please follow the steps below to install VC Credit.
Prerequisites
Installation Area
In order to install the VC Credit in a safe manner, the following conditions shall be satisfied:
1) The kiosk must be placed and leveled on a horizontal, water-resistant, and sturdy pedestal capable of bearing its weight.
2) Please ensure enough space for the front door to be fully swung open for maintenance purpose. You can refer to the top-down diagram of the door swing below for clearance around the kiosk while servicing the kiosk without obstruction.
Single-Sided Kiosk | Service Area |
|---|---|
|
|
3) Make sure the power supply, operating temperature and humidity complies with the Technical Data.
4) The maximum ADA height (the height from the most upper edge of Ultra VXT to the ground) is 1220mm (48.03 inches) as shown in below diagram along with the height of the pedestal and the height from the top of the VC Credit to the ground.
Mounting
Router Installation (if needed)
1) Remove the Antenna Blocking plate on the kiosk, screw off the original nuts of the antenna, pass the antenna through the pre-embedded holes and fasten it with the original nuts. | 2) Connect the Wi-Fi and 4G ports separately to the corresponding positions of the router. |
|
|
3) Fix the router fixing plate to the middle position of both sides with M2.5*6 screws. | 4) Pass the router fixing plate through the right pre-embedded bolt and fasten it with M5 thumb nuts. Note: Turn the router socket side outward. |
|
|
Ultra VXT and Card Dispenser Installation
1) Pass the Ultra VXT to the reserved holes of the front of the kiosk and fix it with thumb nuts. | 2) Insert one end of Card Dispenser Cable-Data -Ultra VXT (WH210015) into the COM port of Ultra VXT. | 3) Pass the sheet metal part of the card dispenser outlet through the reserved bolts and fix them with M5 flange nuts. Pay attention to adjust the position to ensure that the bottom edge of the sheet metal part is flush with the edge of the outlet, and there is no frictional collision. |
|
|
|
Pedestal Mounting
The installation procedure to mount the AVU Credit on the pedestal provided by KioSoft is as follows:
1) Place the pedestal against the wall. | 2) Locate the four fixing holes on bottom plate, drive Φ14*35mm (1.37 inch) holes on the ground and fasten the pedestal to the floor with M10x60 expansion screws. Warning: the kiosk assembly may tip over if the pedestal is not properly fastened to the floor! |
|
|
3) Place pedestal cover on the pedestal bottom and fix it with M5x10 screw. | 4) Fix the vertical plate to cover the pedestal trunk by pushing the plate directly. |
|
|
5) Pull the kiosk cable through the corresponding holes on the kiosk back door and pedestal (see illustration picture) and fix the kiosk back door to the pedestal (marked in white spots) using M8*20 screws and nuts. | |
| |
Warning: The kiosk along with its pedestal is quite heavy, so please ensure that the installation surface is flat. It is also highly suggested that the kiosk is installed with its back close to the wall for security purposes.
Note: Please see the following procedure of expansion bolt usage for reference.
1) Drill a hole of the same size with the expansion tube in the wall. | 2) Place the expansion bolt in the hole and use a wrench to fasten the bolt. | 3) The expansion tube after fastening will expand so the end of the bolt is embedded and fixed to the wall. |
|
|
|
Wall Mounting
The other option to fix the VC Credit is wall mounting with the following procedure:
1) Use the Ф14 mm (0.55 inch) drill to punch 4 holes as shown on the wall and drive in M10*60 expansion bolts. | 2) Pass the pre-reserved holes on back door of VC Credit through the expansion bolts and fix them with nuts. |
|
|
