Support SUT and SSUT
For detailed instructions, please navigate to Drive > Functionalities supported by Elevate Touch and locate the PDF file SUT & SSUT instruction guide.
a. SSUT test
You can enable/disable SUT test in laundry portal > Settings. After that, when creating a profile for the reader in CCM, there is an option “Error Beep for SSUT.” If you enable it, the reader will beep after the setup up until it has passed the test points. The test points will vary based on vendor admin’s SUT options in Settings. The technicians can check the SSUT errors with “Error Enquiries” in KLM or CSC Tech Mobile. Scan the QR code or enter the machine number to check the errors which is not passed in SSUT mode.
b. SUT test
The SUT test can be conducted in two ways:
1) You can scan the QR code of the reader on the KLM app, and enter and confirm the machine number range. The app will send the SUT command to the router.
2) Or you can go to vendor portal and enter the Room View page where you can click on “View” -> “Set Up Test” -> “Start SUT.” Then the server will send the SUT command to the router. The reader will ask for SUT command every 4 minutes. If there exists a SUT command, it will begin the SUT test and then upload the SUT reports.