Mounting
The mounting options for the reader vary depending on the machine. KioSoft offers compatible mounting plates and wiring packages for all machine types. Please contact KioSoft Support for expert advice on mounting and wiring solutions tailored to your specific needs. Below is the list of the typical mounting kits:
[Mounting Plates]
This is the list of the typical mounting kits: List of Mounting Plates
[Drill Templates]
When drilling the plate to mount the reader, you can download the drilling templates below—available in A4 and US Letter—for reference.
Wiring
The wiring methods for the reader vary depending on the machine. Please contact KioSoft for detailed information or visit the link below for the documents applicable to your machine.
How to Use the Jumper and DIP Switches
If the Profile is Universal Pulse：
When Gameboard/Retail Board is connected, move the Jumper to A.
When Gameboard/Retail Board is not connected, refer to the configuration rules in the Table 2.3.1.
If the profile is not Universal Pulse:
Please keep the Jumper at A and all 4 DIP switches OFF.
Notes:
DIP switches are primarily used in “Relay pulse/Relay on/Coin Monitor” settings.
As of the release date of this document, only Car Wash machines require DIP switch configuration.
Scenarios when the profile is Universal Pulse and the Gameboard is not connected.
NO. | Profile | Port | Jumper | DIP Switches (S1) | ||||||
Universal Pulse | ||||||||||
Pulse | Products Price and Timing | Machine Profile | 1 | 2 | 3 | 4 | ||||
1 | Relay on Relay pulse | / | / | J1 | B | OFF | OFF | OFF | OFF | |
2 | Relay pulse Relay on | - Count Up | / | J3 | A | ON | ON | OFF | OFF | |
3 | Relay pulse Relay on | / | - Coin Monitor | J3 | A | ON | ON | ON | OFF | |
Install SIM Card
1) Turn the terminal upside down. Remove the two screws of the card slot cover. | 2) Remove the cover board and expose the card slots. | 3) Insert the card into slot #2 (the lower slot). Keep the engraved marks of the card in line with the slot and the chip facing downward. |
|
|
|
4) Make sure the card is installed in place. | 5) Connect the antenna to the interface at the back of the reader. Note: The reader will not have a signal without the antenna. | / |
|
| / |
