Move out the tray
2) Hold up the front end of the tray, then pull out the tray. | 3) Cut the ribbon fastening the cable at the back side of the tray. | |
|
|
|
4) Unplug the tray cable connector. | 5) Take out the tray. | |
|
|
Adjust the height of the slide rails
1) Remove the tray slide rail screws at both sides. | 2) Unhook the slide rails from the holding holes. | Note: The distance between two contiguous holding holes is 2cm. |
|
|
|
3) Adjust the slide rails to the proper height and fasten with screws. Note: The height of the slide rails at the two sides should be the same. | 4) Install back the tray. |
