Move out the tray

1) Pull up the tray fixing buckle.

2) Hold up the front end of the tray, then pull out the tray.

3) Cut the ribbon fastening the cable at the back side of the tray.

4) Unplug the tray cable connector.

5) Take out the tray.

1) Remove the screws of the tray slide rail at both sides.

2) Unhook the slide rails from the holding holes.

Note: The distance between two contiguous holding holes is 2cm.

3) Adjust the slide rails to the proper height and fasten with screws.

4) Install back the tray.

Note: The height of the slide rails at the two sides should be the same.