Gen 2 VC Touch 21 Secondary Installation Guide

Prev Next

This document is to introduce Gen 2 VC Touch 21 secondary installation.

1. Unfold the Carton Box of Kiosk Chassis

1. Remove the tape and open the carton box.

2. Remove the EPE foam.

3. Take out the Kiosk Chassis. There are two types of Kiosk chassis, one is with wheels, the other one is with foot cups.

2. Unfold the Carton Box of Kiosk Pedestal

1. Remove the tape and open the carton box.

2. Remove the EPE foam and pull out the kiosk pedestal.

3. Install the Kiosk Pedestal

1. Turn the T-lock counterclockwise to open the door of kiosk pedestal.

2. If there is no kiosk chassis, fix the kiosk pedestal on the ground by four expansion screws.

3. If there is a kiosk chassis, put the kiosk pedestal on the kiosk chassis, fix it by four M10*40 screws.

4. Install the Kiosk

1. Remove the tape and open the carton box.

2. Unfold the carton box and remove the EPE foam.

3. Pull out the VC Kiosk from the carton box and put it on the kiosk pedestal.

4. Turn the T-lock counterclockwise to open the front door of VC kiosk.

Note: There must be someone to lift the front door in case that the VC kiosk drops down.

5. Lift the blue head of the slide and pull it out.

6. This is the view under slide. Fix the VC kiosk on the kiosk pedestal by tightening four M10*40 screws.

7. This is the view from the right side.

After fixing the VC kiosk on the kiosk pedestal, there is no need to lift the front door any more.

8. Untie the white power cable and let it go through the hole like this.

3. Install the Antenna

1. Untie the antenna from card dispenser and unscrew the nuts from the antenna like this.

2. Uninstall one of the antenna boards from the upper right corner of VC kiosk.

3. Let the antenna cables go through the hole of VC kiosk like this. Then fix the antenna by tightening the unscrewed nuts.

4. Connect Antenna to the modem by Wi-Fi cable and 4G cable.

5. Power on the kiosk, then turn the T-lock clockwise to close the front door of VC kiosk.