KioSoft Fridge Spec Sheet

1

You should install a suitable automatic voltage regulator not less than 500w.

2

The sockets of the freezer should be connected to stable fixed connection.

Under no circumstance should the wiring be connected to such facilities as water pipe, gas pipe and so on.

3

Once power is cut off ,wait for at least 5 min before plugging in again to avoid damaging the compressor or system.

4

Do not put combustible, explosive or volatile dangerous articles, heavily corrosive acid or alkali of liquid in glassware into the freezer.

5

Children should be kept away from the freezer to avoid damage to the inner container or any accidents and injuries.

6

If the power cable is damaged, to avoid any danger, it should be repaired / replaced by a qualified service technician.

1

Place on level floor and remove the bottom packing, in order to decrease the shock and noise. The angle between the compartment body and ground should be no more than 45°.

2

Enough space should be left between the freezer and the wall for ventilation.

3

Keep the freezer away from heat source and direct sunshine.

4

Do not install at places where there is moisture or where it can easily be splashed by water.

5

Do not place the freezer in environment prone to freezing.

6

The appliance should not be used in open air and should not be exposed to rain.

7

There are three types of caps for holes on fridge (as shown in picture below). Type ① is for the side holes on fridge; type ② & ③ are for the top holes on fridge, only ② is used during the fridge’s daily operation for inserting tubes, while ③ is used during the transportation of fridge for sealing purpose.

1

Adjustment of temperature:

* The storing temperature can be adjusted by the thermostat.

* The thermostat should be adjusted according to different environment temperature and the food.

* There's usually a factory default temperature for this product, which is 4 degrees, temperature difference is ±2 degrees.

Do not adjust too often or touch the other part

2

Trial running: Plug in and wait. The marked drop in temperature within half an hour indicates that the freezer works properly

3

The compressor should be left to run for a period of time (6 hours in summer, 4 hours in winter) before putting any food in.

1

Do not put too much food into the freezer or exceed the load limit.

2

Proper space should be allowed among foods to ensure cooling air circulation.

3

Never use corrosive detergent, hot water, or washing powder to clean the freezer.

4

Do not use water to flush the freezer. Do not use hard brushes or wire brushes to clean the freezer.

5

Do not use metal or sharp tools for defrosting.

6

Do not use electric heaters to heat up and defrost.

7

Control the opening time of fridge, do not leave the door open for a long time.

8

Limit the frequency of opening the fridge, do not open it too often.

9

Ensure the fridge door pads are complete and well tightened to achieve good sealing effect.

10

The recommended temperature to prevent ice build-up is 4℃, if set lower than this, ice build-up could occur.