1) Move out the tray
1) Lift up the front of the tray a little bit. | 2) Hold up the front end of the tray, then pull out the tray. | 3) Cut the ribbon fastening the cable at the back side of the tray. |
|
|
|
4) Unplug the tray cable connector. | 5) Take out the tray. | |
|
|
2) Adjust the height of the slide rails
1) Remove the screws of the tray slide rail at both sides. | 2) Un hook the slide rails from the holding holes. | Note: The distance between two contiguous holding holes is 2cm. |
|
|
|
3) Adjust the slide rails to the proper height and fasten with screws. | 4) Install back the tray. | Note: The height of the slide rails at the two sides should be the same. |
3) Program the Tray Height and Elevator
Login the Android management system with admin account. Go to “Debug” -- “Move” section by the main menu at the top side. In this section you can test the movement of the elevator, adjust the elevator height to each layer, test if the layer height is collaborated with the movement of the elevator, etc.
Layer height setting
Layer height adjustment and testing
Select the layer to be queried;
Elevator move to this layer to check if it’s the proper position;
Adjust the height by input the layer number and height;
Check the elevator position again;
