1) Move out the tray
1) Pull up the tray fixing buckle. | 2) Hold up the front end of the tray, then pull out the tray. | 3) Cut the ribbon fastening the cable at the back side of the tray. |
| ||
4) Unplug the tray cable connector. | 5) Take out the tray. | |
2) Adjust the height of the slide rails
1) Remove the screws of the tray slide rail at both sides. | 2) Unhook the slide rails from the holding holes. | Note: The distance between two contiguous holding holes is 2cm. |
3) Adjust the slide rails to the proper height and fasten with screws. | 4) Install back the tray. | Note: The height of the slide rails at the two sides should be the same. |
3) Program the Tray Height and Elevator
Login the Android management system with admin account. Navigate to “Advanced setting” section by the main menu at the left side. In this section you can test the movement of the elevator, adjust the elevator height to each layer, test if the layer height is collaborated with the movement of the elevator, etc.
Parameter Settings
Go to number X layer: enter a layer number, and the elevator will ascend to its corresponding height. This function can help you verify whether the elevator's position aligns with the set layer height.
Parameter query: to query the height for each layer.
Parameter Settings: to set the elevator height for each layer. Enter the layer number and its corresponding height (mm). For example, if you set Layer 1 to 100 mm, then select " Layer 1" in the “Go to number X layer”, the elevator will raise to 100 mm to reach layer 1. Click "Set Up" to save your settings.