EDC Wiring Instructions

Document Overview

The objective of this document is to cover how to setup an Alliance EDC controlled machine.  This document goes over the wiring of an Alliance EDC machine with harness WH120010 and power kit PK110062, if using coin WH120036. Additionally, how to create a the machine’s profile in the Cloud Configuration Manager, used for programming the KioSoft card reader.  

Parts List

Connections Illustration

Before Installation

Wiring Instructions

Coin Connection

1. Disconnect the machine board’s 3-pin cable from Alliance’s coin drop.

2. Plug in Alliance’s coin drop into harness WH120010’s coin cable (red, black & white).

****If you are having issues finding the coin drop connection. See images below. On the EDC board, the “H2” connection leads to the 3-pin coin drop connector.

Coin Pulse cable (Required to pulse the machine)

If keeping coin, take the machine board’s 3 pin coin cable (coming from H2 on the board) and plug it into Pulse Output Cable WH120036 (red & white). The other end of WH120036 goes to the back of the reader’s pulse port. See the “Additional Information” section to view the coin pulse port locations on different reader types.  

Note: Please keep the card reader’s jumper on A side.

Power Connection

Please consult the Owner’s Manual, under the installation section, before fully connecting WH111004 & PS100007 Power Adaptor to your laundry machine. Depending on the machine model and voltage, connections may vary. PS100007 Power Adaptor accepts a wide input from 100-240 V – 50-60HZ 0.8A and output of 12V.  

WH111004 is fed from the front of the machine through the back, to reach power connections. Then Connect WH111004 to the AC adapter PS100007’s 2-pin connector.

Afterwards, plug in the AC adapter PS100007’s 2-pin female connector to the MDC harness’s power cable, black and white.

Card Reader Connection

Plug card reader’s data cable into harness WH120010’s card reader cable.

Creating a CommonPulse profile for EDC

Under CCM, in the Profile Builder:

Select the following for Machine Data/mdata:

Manufacturer: “CommonPulse”

Machine Control Type: “Washer”

After, click on "Advance Options" to view all fields:

         Configure machine parameters/fields as needed:

                     Note: All parameters in the machine’s profile will need to match what is set on the machine board.

         The Cycle Time is the amount of time the reader will not accept payment once the machine is in use. Please make sure to change the cycle time as needed.

          Enter the following pulse setting for an EDC machine.

Once machine values are configured, click on “Site Data” and enter location information.

• Site Code and Location ID must match the location in Location Management on Laundry Portal

• For Location ID and Room#, you should enter the ones that you created previously

See image below regarding Site Data’s field values.

If applicable, for Payment Options, ensure you select the payment methods for the desired location.

Finally, select “Save Profile” from the drop-down menu and click “Save”

• Enter “Custom Text” for easier identification in the KioSoft Laundry Manager Application.

• Example of Custom Text Label: Location Name RM1 EDC Dryer [225/45mins]

Additional Information