Overview
Instructions
Steps 1-3 are optional. You can follow these steps to remove the metal plates so that you can add cards easier and add the metal weight to prevent the cards from getting stuck.
For the future shipment of VCs, Metal plates on the back of the card dispenser will not be installed during factory assembly.
Remove the power first. This is the back view of the card dispenser.
| Turn screws out counterclockwise to remove the board.
|
| 
|
Remove all three boards on the back of the card dispenser.
| Put cards into the card dispenser and make sure the cards are stacked neatly.
|
| 
|
Slide the metal weight into the card dispenser from the top to the bottom.
|
| 
|
Make sure the Metal weight is in place.
| Check the card dispenser transportation belt for safety and then power on for use.
|
| Intentionally Blank |