Parts List

Parts Illustration

     WH120011 ACA harness with Coin Drop Connector
     

Safety reminder: Please unplug washer machine prior of installation of KioSoft Equipment

Changing machine board to SERIAL mode

With the ACA machine off, verify the machine is set to “Serial Payment System” mode by looking at the dipswitches on machine board.

Dipswitches are located on the bottom left of the board. Only dipswitch 3 needs to be on, all others are off. See example of machine board images below.

If the machine is left on while making changes to the dipswitches, the changes may not take effect. Power cycle the machine afterwards.

Image: Logic board zoom in with Dipswitch set on number 3

Wiring Instructions for connector solo readers

Remove front panel screws of the machine to reveal ACA motherboard. Example of machine board shown below.

                                             Image: Machine board open view

Serial Connection

Connect the WH120011’s card reader serial cable to the machine board, located on the top left-hand side.

                          Image: WH120011’s serial cable connected to machine board

Power Connection

There are two methods for getting power from machine, depending on the type of reader.

1. For Connect & Solo Readers, use the “H10” on the ACA motherboard and WH120020, included in harness kit. H10 connection on the board is located above the dipswitches.

                      Image: connection to ACA motherboard

1. Connect KioSoft harness female power cable (black & white) to male connection on WH120020.

2. Then connect the female end of the WH120020 cable to the “H1” connection on the board.

              Image: WH120020 wire connection to Motherboard

Wiring instructions for Ultra reader settings

2. For Ultra reader, reader will receive power using the transformer with additional parts: AC/Adaptor PS100007 with WH120021, and WH120015.

                                    Image: WH120021 Wire

                                  Image: WH120015 wire

                      Image: PS100007 AC power adaptor

1. Disconnect the machine’s transformer connection

   

2. Connect machine’s male transformer connection to WH120021’s female power connection.

    Then WH120021’s male power connection to machine’s female transformer connection.

   

3. Connect the third cable (male connector) from WH120021 to the AC/Adaptor’s female connector (brown & blue) and the other end of the AC adaptor cable (male connector, red and black) to WH120015 female connector.

4. Finally, connect WH120015 into WH120011 harness’s cable (black and white).

Coin connection, if appliable

Connect the machine's coin cable into WH120011’s 3-pin male coin cable (red, black & white).

Reader connection

Plug card reader’s data cable into harness WH120011’s card reader cable

Creating an ACA profile

Under CCM, in the Profile Builder:

Select the following for Machine Data

Select manufacturer as “Aliance”

Select Machine Control Type as “ACA”, then, select machine type:

Please note: The ACA laundry machines from year 2020 need an ACA MAX profile.

With an ACA MAX profile, the reader is pulling the vend price from the machine board. You must set the desired vend price on the machine board.

After, click on "Advance Options" and configure machine fields (vend price, time, etc.,) as   needed.

Once machine values are configured, click on “Site Data” and enter location information.

• Site Code and Location ID must match the location in Location Management on Laundry Portal

• For Location ID and Room#, you should enter the ones that you created previously

See image below regarding Site Data’s field values.

If applicable, for Payment Options, ensure you select the payment methods for the desired location.

Finally, select “Save Profile” from the drop-down menu and click “Save”

• Enter “Custom Text” for easier identification in the KioSoft Laundry Manager Application.

• Example of Custom Text Label: Location Name RM1 ACA Dryer [225/45mins]