This document reviews MFR30’s board programming, wiring, and CCM Profile configuration
1) MRF30 Board Programming:
Note: MRF30 Machine must be set to coin and debit mode
(This ensures cycle status, otherwise reader will not sense cycle stopped)
Programming the machine:
Turn the Service key to switch from RUN mode to SERVICE
In Service – SET-UP mode, the Main Menu Screen appears
> “Pricing Menu” (2nd option listed)
> “General” (Set-up of Pricing related functions)
> Change payment selection to “Coin & Card” (2nd option listed)
2) MRF30 Harness Wiring:
Machine: MFR30PD PK: Pending Assignment of PK Number
Coin Connections - Remove machine’s original clear tab connections according to the following directions
Coin Out to Machine
Machine green to harness green cable
Machine blue to harness blue cable
Machine red to harness red cable
Coin In to Terminal
Machine terminal red to harness green cable
Machine terminal blue to harness black cable
Third connection on terminal – Machine's green cable with clear tab remains on terminal
Machine terminal yellow to harness white cable
Coin one – and two
Power supply connection:
The AC Power Adaptor (PS100007) with Brown & Blue pin connector is connected to WH120006 (Black & White Cable)
WH120006 cable uses the blue splice tabs to tap into power on machine. Located on the top left side of the machine (shown in a red circle; see image below)
Splice WH120006’ s black cable to machines' black cable
Splice WH120006’ s white black cable to machines' white cable
Serial connection (orange and black cable) from harness to Machine’s motherboard
Harness’s card reader connection to mesh cable on back of reader
The jumper on the back of the card reader needs to be changed from “A” to “B” side
3) MRF30 Profile:
Reminder: When using Common Pulse in CCM
Creating the profile for MFR30 PD under CCM profile builder using the following settings:
CCM Profile > Machine Data > Common Pulse > Washer (Remember to also match the vend price on the board + profile)
Pulse Width: 30
Pulse Rate: 100
Pulse Type: Low