Document  Overview

The objective of this document is to cover how to setup a Maytag MAT20 with a KioSoft card reader. This document goes over the wiring of an MAT20 using a single pocket harness and, if applicable, a coin pulse cable. Additionally, how to create a machine profile in Cloud Configuration  Manager.

Parts List

Connections  Illustration

Before Installation

PLEASE UNPLUG LAUNDRY MACHINE

PRIOR TO INSTALLATION OF HARNESS

Wiring Instructions

Access the machine board by removing machine’s display panel. Removed the four screws as shown below.

Example image of Maytag Single Pocket  motherboard

Power Connections

Remove Maytag transformer connection on machine board, label as “AA6 TRANSFORMER”

Connect the Maytag transformer cable into the KioSoft harness's female connection power connection and place the other power connection on the harness to the board

Serial Connection

Plug in the KioSoft harness’s 6-pin serial connection (Black, Orange, Yellow and black cables) to machine board labeled “AA3 CARD READER.”, as shown in image below.

Card Reader Connection

Plug card reader’s data cable into WH130005’s card reader connection.

For PD models only

Connect coin drop cable to harness’s coin cable (Green, White, Black)

Connect WH130018’s 2 by 2 pin red and white coin cable to machine’s board on Coin1 and NOT Coin2, then connect other end of coin cable, 3 pin connection to pulse port located on the back of the reader. See “Additional Information” section to view different KioSoft reader’s pulse ports.

Note: If you need a longer coin cable, please use WH130020 instead of WH130018. Part number WH1300020 is a 90cm longer coin cable. Additionally, you can use the longer harness WH130022  in place of  WH130005

Creating a MAT20 profile in CCM

Under CCM, in Profile Builder for Machine Data/mData enter the following information: Select Manufacture: “Maytag”

In the search bar, enter the model number partially as “MAT20” to autofill or click on the

following for MAT20:

Rec = 47

Model = 17

After, click on "Advance Options" and configure pricing as needed.

Please note on the KLM app: When programming the machine information make sure to check

off “Enable coin Via Gen1” option, if using coin.

Once machine values are configured, click on “Site Data” and enter location information.

• Site Code and Location ID must match the location in Location Management on Laundry Portal

• For Location ID and Room#, you should enter the ones that you created previously

See image below regarding Site Data’s field values.

1. Location ID

2. Site Code

3. Room Number

   • Each room will get its own profile.

4. Non-Network

   • This should be enabled any time a modem is not present in the room.

5. Card Holder

6. Hide Label

   • This will hide the machine number on Connect and Elevate readers

If applicable, for Payment Options, ensure you select the payment methods for the desired location.

Finally, select “Save  Profile” from the drop-down menu and click   “Save”

• Enter “Custom Text” for easier identification in the KioSoft Laundry Manager Application.

• Example of Custom Text Label: Location Name RM1 Maytag Single Dryer [100/45mins]

Additional  Information