Document  Overview

The objective of this document is to cover how to set up a Maytag MHN33PD using coin. This document goes over the wiring of MHN33 with KioSoft Single Maytag harness and a coin pulse cable. Additionally, how to create a the machine’s profile in the Cloud Configuration Manager, used for programming the KioSoft card reader.

Parts List

Harness  Connections Illustration

Harness  Wiring Instructions

To access the machine's motherboard:

First remove the soap dispenser. Press on latch, located at the top (see image middle image), to release and remove the soap dispenser completely. Next, remove the two screws located on the inside of where the soap dispenser was located.

Then remove the four screws from the display panel and remove the machine frame afterwards.

Remove additional screws 6 screws, located on the outer left and outer right sides of the machines metal frame to access the machine board.

Remove the original Maytag power connection (White, yellow and blue cable), as shown in the image of

MHN33’s motherboard below.

Place KioSoft harness’ power connection (of the same cable colors as the original Maytag power cable) into the motherboard and connect the original Maytag power connection to the KioSoft harness.

Connect KioSoft harness’s serial connection (Black, Orange, Yellow and black cables) to machine board labeled “CARD READER”, as shown in image below.

Creating a profile for MHN33 in CCM

Under CCM, in the Profile Builder select the following for Mdata

Select “Maytag”

You can enter the model number partially as “MHN33” to autofill or click on the following for MHN33: Rec = 37

Model= 16

After, click on "Advance Options" and configure pricing as  needed

Finally  enter "Site Data" for location  and save profile with “Custom Text” for labeling profile.

Creating  a profile for MDE28 in CCM

Under CCM, in the Profile Builder select the following for Mdata

Select “Maytag”

You can enter the model number partially as “MDx28” to autofill or click on the following for MDE28: Rec = 27

Model= 8

After, click on "Advance Options" and configure pricing as  needed

Finally  enter "Site Data" for location  and save profile with “Custom Text” for labeling profile.

Additional Information